Quote:
Originally Posted by HBWT
To install an Execuhitch the bumper must be removed/replaced so while that was off I ran the wiring through the same grommet being used by the PDC sensors. It was a tight squeeze but worked just fine.
Had I not been able to do that I was prepared to drill a hole, prime and paint the bare metal, and insert a proper size grommet. That would not have been a problem. Second to the tune, the Hitch was my most appreciated add-on.
|
thanks !!!
i will look again, i am installing a curt hitch, it does not require the bumper to be removed only the trim where the sensor are located. i am hoping i will have enough access to pass the wires