Quote:
Originally Posted by digitalatlas
Hi everyone,
So I decided to put on PPF into the full hood and front bumper, about 7000km since it was color corrected and buffed out.
I noticed that there's a small 2mm chip that I didn't touch up, and now it's under the PPF. It's the lower part of the bumper, can see it unless you're pretty close. It's the plastic part so I'm not really worried about rust.
Is it ok if I just use a brush and dab on a bit of touchup paint onto the PPF? Is that going to eat through the PPF? I could just leave it but sometimes is bothers me when I see that spot.
I used the touchup Rx kit with the touchup paint and pink leveler. I guess I should not use any leveler because I think it must be some acetone based solvent. Any thoughts?
Thanks.
|
I wouldn't touch it as I don't think it will look ok. If you hate the way it appears now, this might be even worse!
