X1 LED upgrade fault flickers

[Lknight]

Hi everyone,

I recently changed the low beams and high beams on my x1 2013 to LED plug and play lights. They work fine and i have managed to remove all fault codes through bimmercode by switching the hot and cold monitoring to not active.

Though despite doing all this everytime i start the engine the lights momentarily flicker and then after this they are fine. I have heard to switch off all hot/cold monitoring which i think i have done on expert mode bimmercode but i am still getting this issue when starting the engine?

Any advice at all would be appreciated?


Thank you

[cwickberg]

You can get anti Flickr devices or resistors... this helps with the flickering. Coding only takes care off the monitoring of the current draw.

Lots available on Amazon