05-15-2014, 10:45 PM | #1 |
New Member
2
Rep 11
Posts |
BMS tune placement
I'm about to install a BMS stage 1 tune on my X1, wondering where to place the control box.
Anyone who installed a BMS tune (be it stage 1 or JB4) please tell me where do you place the control box and, if possible, show a picture. Thanks in advance. |
05-16-2014, 12:05 PM | #3 | |
New Member
2
Rep 11
Posts |
Quote:
The problem is, the instruction PDF they provides is for F30, which has a significant different engine bay. I can't place the control at the top right hand corner under some rubber seal as I could have F30. So I really need advice on this, where to place the control box to keep it secured, clean and try in E84's engine bay. Any advice will be appreciated. |
|
Appreciate
0
|
05-16-2014, 03:41 PM | #4 |
Second Lieutenant
32
Rep 279
Posts |
There are separate instructions for E9X series cars... If i remember, they refer you to the N54 video or instructions...Typically install your box where the ECM is
|
Appreciate
0
|
05-17-2014, 04:20 AM | #5 |
New Member
2
Rep 11
Posts |
Thanks man. I looked up the E series N55 instruction and it hinted a good spot placing the control box.
|
Appreciate
0
|
05-17-2014, 01:54 PM | #6 |
teh porcupine
96
Rep 1,726
Posts
Drives: 2020 Tesla 3 LR AWD
Join Date: May 2011
Location: penthouse
|
If it's similar to the N55 135 JB4 install, I taped some foam to one side of the JB4 with painters tape. Then I put the JB4 into the ECU box. The foam kept the JB4 from bouncing around and the painters tape was easy to remove.
__________________
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|