Quote:
Originally Posted by D Unit
I want say both 1 and 2. I cannot go lower because I've threaded the collar all the way down.... And I can not go lower because I'm already set minimal preload.
|
Wait, what?
Pick from these options:
1. You threaded to lower spring perch (the green one in the pic, no one cares about the lower red collar) all the way down
until it hit the sleeve (or the red collar just above the sleeve), AND that position just happens to also be the minimum preload? If that is the case, use a shorter spring plus a helper.
2. Or does yours look like the pic you posted. AKA you threaded the spring perch down to the minimum preload, SO you can't thread it any lower (but there is in fact room to physically thread it lower...as there is in the pic)? If that is the case, try just a helper (if not a longer primary spring).
__________________
'02 S54 M3 (500/500 GC/Koni)
'08 N54 135 (JB4, DCI, BMW PS/Bilstein B6s, H&R M3 FSB, Strongflex FCABs)
'14 N55 X1 (JB4, BMS DP, BMS Intake, Alpina TCU reflash, H&R Sports, Bilstein B6s, E93 M3 RSB, Strongflex FCABs, baby seat)
'08 N54 535xi touring (Bilstein B6s, Downpipes, MHD tune, baby seat)