Hi everyone.
I just purchase a 2014 X1 28i Xdrive. 120K miles.
I had error codes P0172 & P00BD, after some quick google search
, I replaced the MAF sensor (Bosch) , spark plugs, oil, air filter, valve cover and gaskets.
Cleared the codes and they keep coming back.
I have a few other random issues, like the driver side doesn't work via switch, all other windows work independently. I can use the key fob to roll down/up all the windows.- *I have already bought two master switches with the same results.
The heater isn't blowing through the front or lower vents, and it doesn't appear to be blowing hot air, nor A/C.
Below is the Error Memory report from Bimmer Code:
Any advice will be appreciated.
00 Safety and information module (SIM)
2 errors
A73E: DC-DC CONVERTER DSC / DXC E84
A6C8: HECKSCHEIBENHEIZUNG_RELAIS
12 Motor electronics
2 errors
2774: 0x2774 Air mass, plausibility: air mass too high
2BC1: 0x2BC1 Mixture control: Mixture too rich
20 Tyre pressure control
4 errors
6054: Error wheel sensor VL
6055: Error wheel sensor VR
6056: Error wheel sensor HL
6057: Error wheel sensor HR
56 Roof function centre
1 error
A670: Error fitting sensor 0xA670
60 Instrument panel
1 error
A56F: CAN_ID_2C3_ERROR_ID-Ausfall_oder_Alivefehler__COMBOX_ECall
2
62 MOST/CAN gateway (headunit/radio)
2 errors
E190: Ring fracture diagnosis was performed (Error_Ring_Diagnose).
E18F: Central registry does not match the target configuration (Error_Registry_New).
72 Basic body module
1 error
9CBA: Communication with LIN keypad interfered
78 Heating/air-conditioning control
8 errors
9C56: Temperature sensor footwell
9C5F: Temperature sensor ventilation
9C62: Temperature sensor evaporator
9C4C: Footwell flap (LIN)
9C52: Ventilation flap (LIN)
9C48: Mixed air flap left (LIN)
9C49: Mixed air flap on the right (LIN)
9C4A: Fresh air / circulating air / dynamic pressure flap (LIN)