|
I believe I was the first to post this mod but sorry never took any pics except when I recieved the parts. I recall there are 8 torx screws at bottom then one plastic pin at each end of the front and rear wheel well, you only need to remove one at each well. I removed it in order to drop the plastic protection guard. Once these are out then you just pull the trim toward you. It has these small press in pins. It is a very easy install a 2 in my opinion of difficulty. You will need to buy the new pins through bmw or hard wear store. It's best just to get down near there and check out the screws, pretty sure it was 8 more or less and I did drop another screw believe it is an 8mm that held the guard as well. Trust me it is nothing that you will start and can't finish. I mounted everything without the pins then drove to bmw, bought the pins and installed later. Check out tisher bmw for schematics that show the parts that will pretty much show you everthing you need to know. Good luck bro
|