View Single Post
      11-04-2012, 09:42 AM   #3
Bill B.
Lieutenant
Bill B.'s Avatar
United_States
18
Rep
439
Posts

Drives: '18 M2, '13 X135i '15 S1000R
Join Date: Sep 2011
Location: Cary, NC

iTrader: (0)

Step 3 - A Pillar Trim

Step 3 - Remove A pillar trim
Probably the most difficult part of the install is removing this trim.

SINCE THE AIRBAG IS UNDER THIS TRIM, YOU MIGHT WANT TO REMOVE POWER BEFORE CONTINUING

First, remove the airbag cap covering the single torx bolt holding the trim to the car. Using a small pick to carefully get under the cover, gently lift until you can squeeze the two tabs and lift off.

Next, Unbolt the torx bolt. It is held with locktite blue so it will take a little effort to unscrew.

Now, two tabs are holding the pillar to the car, so pulling the pillar toward the rear of the car, and up, while wiggling will eventually loosen the pillar for removal. (SHORTCUT: Just pull the trim away from the pillar, removing the trim clips still attached to the pillar trim.)
Attached Images
   
Appreciate 0