View Single Post
      09-03-2013, 11:19 PM   #11
Kaneda215
0
New Member
 
Drives: 2013 BMW X1
Join Date: Nov 2012
Location: Laughlin AFB, TX

Posts: 22
iTrader: (0)

A few things I felt worth noting after my installation.

1. I believe the TORX bit needed for the A-pillar was a size 40. The ones used for the glove box are a pretty standard size found in a basic tool kit.

2. If you elect to go the route without using the tapa, you definitely need to go out and buy a male spade. It took me a while to figure out which one to use:

The #10 spade at a 16 gauge seemed to work fine. Just strip the cable coming from the V1 adapter AFTER the fuse (so that the Fuse is still there), and crimp on the spade.



Edit: wording

Last edited by Kaneda215; 09-04-2013 at 01:03 AM.
Kaneda215 is offline  
Appreciate 0
Reply With Quote