View Single Post
      11-04-2012, 12:10 PM   #7
Bill B.
Bill B.'s Avatar

Drives: '12 135i, '13 X135i '15 S1000R
Join Date: Sep 2011
Location: Cary, NC

iTrader: (0)

Step 7 - Buttoning Up

Step 7 - buttoning up
Assembly is done in the reverse. A few notes: the A pillar trim is most easy to re-install by removing the two nylon clips from the metal pillar and sliding into the slots on the back of the pillar trim. This way, the trim can just be pushed back into place, instead of trying to slide it back into place.

You may want to use more locktite to reset the torx bolt holding the A pillar trim in place.

Replacing the glove box is easiest done by putting it back in place and closing it before trying to re-install the pivot rod brackets.